4 tiller drive (tiller pilots only), Critical dimensions, Tiller drive (tiller pilots only) – Raymarine autopilot + ST4000+ User Manual
Page 74
Chapter 5: Installing the ST4000+
59
5
5.4 Tiller drive (tiller pilots only)
Critical dimensions
Installing the tiller drive involves mounting it between the tiller and a
fixed point on the boat’s structure. Two dimensions are critical for
correct installation:
•
Dimension A = 620 mm (24.5 in): the distance from the
mounting socket to the tiller pin. Pull out the drive pushrod to this
dimension.
Note: If your installation requires a pushrod extension (see page 61)
or cantilever mount (see page 65),this dimension will increase.
•
Dimension B = 460 mm (18 in): the distance from the rudder
stock’s center line to the tiller pin.
'A'
620 mm (24.5 in)
468 mm (18.4 in)
38 mm
(1.5 in)
44 mm
(1.7 in)
'B'
460 mm
(18 in)
'B' 460 mm (18 in)
D5339-1
90˚
Sloping rudderstock
Rudder axis
- RAYTHEON E32001 (13 pages)
- RAYCHART 420 (101 pages)
- L365 (83 pages)
- SR50 (48 pages)
- A65 (100 pages)
- RS12 (50 pages)
- DSM300 (82 pages)
- NMEA Multiplexer (16 pages)
- Pathfinder (111 pages)
- Pathfinder Radar (244 pages)
- autopilot control unit (111 pages)
- VolvoPenta IPS Autopilot System DPU (16 pages)
- stand-alone master instrument (45 pages)
- ST80 (15 pages)
- Raystar 125 (8 pages)
- RS12 (38 pages)
- ST6001 (48 pages)
- Pathfinder Radar Scanners (66 pages)
- Chartplotter (101 pages)
- Heading Sensor (24 pages)
- Ray430 (54 pages)
- Viewable Marine Displays (38 pages)
- Marine GPS System (188 pages)
- C Series (244 pages)
- ST8001 (48 pages)
- hsb2 PLUS Series (246 pages)
- 631 PLUS (170 pages)
- navigation system (17 pages)
- ST8002 (48 pages)
- PowerPilot (18 pages)
- ST7002 (52 pages)
- GPS Kit (24 pages)
- 465 (107 pages)
- Ray54E (116 pages)
- GPS Plotter (131 pages)
- GPS navigation (75 pages)
- ST7001 (48 pages)
- 300 (136 pages)
- Raystar 120 (30 pages)
- autopilot (137 pages)
- DSM30 (34 pages)
- Platinum Chart Card (29 pages)
- ST6002 (56 pages)
- 320 (139 pages)