Raymarine autopilot + ST4000+ - Manual (Page 22)

Chapter 2: Basic Operation 7
2
Bas
ic Op
er
atio
n
CAUTION:
Autopilot course control makes it easier to sail a boat, but it is
NOT a substitute for good seamanship. ALWAYS maintain a
permanent watch, no matter how clear the sea appears to be.
Disengaging the autopilot (Standby mode)
1. Press standby.
• in Standby mode, the display shows the boat’s current
compass heading.
2. Disengage the autopilot to return to hand steering:
• Wheel Pilot: Disengage the wheel drive clutch by rotating the
clutch lever anti-clockwise (so the lever engages fully onto
the locating pip).
• Tiller Pilot: Remove the drive unit from the tiller pin. If
required, retract the push rod using -1, +1, -10 and +10 keys.
3. The last heading is memorized and can be recalled (see page 9).
CAUTION: Wheel drive systems
On wheel drive systems, always make sure that the clutch is
FULLY DISENGAGED before you leave the boat.
D3561-2