Serial communications, 1 rs-232 connection and port configuration, 2 serial command syntax – Runco CL-610 User Manual

Page 65: Table 6-1 . serial commands, Rs-232 connection and port configuration, Serial command syntax, Pre l iminar y

Runco CL-610 Series Owner’s Operating Manual

PRE

IMINAR

6.1
RS-232 Connection
and Port Configuration

To interface the CL-610 with a home theater automation/control system or a PC running
terminal emulation software:

1. Connect it to your control system or PC as shown in Figure 3-8.

2. Start a terminal session on your PC using a terminal-emulation program, such as

HyperTerminal.

3. Configure the RS-232 controller or PC serial port as follows: no parity, eight data bits,

one stop bit and no flow control. Set the baud rate to match that of the projector
(115200, 38400 or 9600).

4. Press

You should see a command prompt (>) in the terminal window.

5. Type a command from among those listed in Table 6-1 and press

For

example, to change the aspect ratio to Letterbox, type

x063x

6.2
Serial Command
Syntax

Serial commands to the CL-610 take the following form:

• Commands are in ASCII format.

• Commands are not case-sensitive;

X001X

and

x001x

are equivalent.

• A carriage return MUST follow each command.

6. Serial Communications

The CL-610 will not accept serial commands for 30 seconds after it
is turned on or off.

Table 6-1. Serial Commands

Code

Function

x001x

Power On

x002x

Power Off

x003x

x004x

Enter

x005x

Exit

x006x

Up (arrow key)

x007x

Down (arrow key)

x008x

Left (arrow key)

x009x

Right (arrow key)

x011x

Show active source and aspect ratio information

x021x

Keypad 1

Note