Roland KR-17 - Manual (Page 165)

165
Chapter 9 Various Settings
Chapter9
■ Restoring the Factory Settings
(Factory Reset)
You can return the content stored with “Memory Backup” (p.
164) and the User Programs (p. 122) to their original factory
settings. This operation is referred to as “Factory Reset.”
* When you perform a Factory Reset, all settings that have been
stored in memory up to then are erased and reset to their
factory defaults.
→ This operation does not return the touch screen calibration
settings to the original factory condition. To return the touch
screen calibration settings to the original factory settings, refer
to “Returning the touch screen calibration settings to the
original factory settings” (p. 165)
→ When you want to restore the content registered to the KR’s
User memory to the factory condition, refer to “Formatting the
User Memory” (p. 165).
At step 3 in “Procedure” (p. 161), touch “Factory Reset.”
A screen like the one shown below appears.
fig.d-factory.eps_50
Touch .
The confirmation message appears on screen.
Touch to restore the original factory settings.
When the setting is changed, the previous screen returns.
When you touch , the settings are left untouched,
and you’re returned to the previous screen.
* Never turn off the power while the display indicates
. Doing so will damage the KR’s
internal memory, making it unusable.
■ Calibrating the Touch Screen
(Touch Screen)
If you’ve been using the touch screen for some time, the
pointer may be shifted, making the KR react incorrectly. You
should correct this displacement when necessary by
performing calibration (repositioning).
At step 3 in “Procedure” (p. 161), touch “Touch Screen.”
A screen like the one shown below appears.
fig.d-touchpanel.eps_50
Touch .
Touch the points indicated.
* Do this carefully, because touching a location that’s different
from the one indicated for the pointer may make the
displacement even worse. Be sure to touch the pointer
accurately.
When the calibration is finished, touch to store the
settings.
* If you don’t write them to memory, the calibration settings
will be discarded as soon as the power is switched off.
Returning the touch screen calibration settings
to the original factory settings
If you touch in the above screen, the touch
screen calibration settings revert to the original factory
settings.
Formatting the User Memory
The KR features an internal storage area where you can save
recorded performances and User Styles. This space is called
the “User Memory.”
The following content is stored to the user memory.
• Content registered to the “Favorites” (p. 80)
• Sets of saved User Programs (p. 123)
• User Styles saved on user memory (p. 149)
• Image files set with the “User Image settings” (p. 163)
To delete all of the content held in the user memory and
restore the original factory settings, carry out the following
procedure.
KR-17_15_e.book 165 ページ ２００４年１２月６日 月曜日 午後１時５４分