Runco LIGHTSTYLE LS-7 - Manual (Page 91)

Serial Communications
Runco LS-7 Installation/Operation Manual 75
PRE
L
IMINAR
Y
status ? 0 = Standby
1 = Powering Up
2 = Displaying
3 = Cooling Down
4 = Error
errcode ? Refer to RS-232 Error
Codes, below.
msgbox = ? 0 = On
1 = Off This control enables or
disables the display of
power off, source and
adjustment message
boxes (brightness, con-
trast etc.). Default value is
ON.
cal.text1
cal.text2
cal.text3 = Up to 30 characters. The LS-7 start-up screen
is customizable with three
lines of text of up to 30
characters each. This text
appears below the “CALI-
BRATED FOR:” text in the
logo screen. The allow-
able characters are all
numbers, letters (upper-
case and lowercase),
spaces, and symbols
available in the ASCII code
set.
Table 6-2. Serial Commands (continued)
Operation Commands Values Notes