Roberts Radio STREAMTime - Manual (Page 46)

45
Setting the alarm clock
Your clock radio has two separate alarms which can be set to wake you
to buzzer, Auxiliary In, internet radio or FM radio. Each alarm can be set
to sound either once, everyday, weekly, weekdays or at weekends. In the
event of a power interruption your radio has a built in memory chip that
will retain your alarm settings.
Note: If no buttons are pressed for 10 seconds the radio will exit the alarm
setup. If you make a mistake at any point, use the Back button to go back
to the previous screen.
1. Press and hold Alarm 1 or Alarm 2 button. 'Enable Alarm' will show
on the display and 'YES' will fl ash. Press the Select button to enable
the alarm and to enter the alarm setting menu. The Alarm hour will
fl ash on the display.
If you do not wish to enable the Alarm press the Tuning Up button
until 'NO' is fl ashing on the display then press the Select button. Your
clock radio will exit the alarm setup and will show 'Alarm disabled'.
2. Press the Tuning Up or Down buttons to set the correct hour. Press
the Select button the minute digits will fl ash.
3. Press the Tuning Up or Down buttons to set the correct minutes. Press
the Select button the alarm frequency option will be displayed.
Once - will sound at one time only
Everyday - will sound everyday.
Weekly - will sound once every week.
Weekdays - will sound on weekdays only.
Weekends - will sound on weekends only.
2,3 2,3
1-3
1