Radio Shack TAD-728 - Manual (Page 37)

37
2. When the outgoing message ends,
press then enter your 2-digit PIN
within 2 seconds.
The TAD announces “You have xx
new message(s)” (where xx is the
numbers of messages) or “You have
no messages,” then the TAD plays
back the recorded messages contin-
uously. When you have both old and
new messages, the TAD first plays
back only the new messages. Press
8 to hear the old messages.
3. During playback, you can press the
number key for the command you
want.
After all messages have been played
back (or you finished playing back by
pressing
), you can continue to ac-
cess other features.
To record a new outgoing message:
1. Press 1 twice within 2 seconds. The
TAD beeps.
2. Record your new outgoing mes-
sage.
3. Press 1 or . A beep sounds and
the recorded outgoing message
plays back.
To record a memo:
1. Press 3 . The TAD beeps.
2. Record your message.
3. Press 3 . The TAD beeps and the
recorded memo plays.
To listen to help guidance:
Press and the TAD plays a series of
voice prompts to guide you through re-
mote operation.
To set the TAD to answer/not answer
calls:
Press 4 . The TAD announces the cur-
rent outgoing message or “Answer off.”
Repeatedly press
4 during the OGM
playback to turn the TAD on, choose
one of the prerecorded or your own
message, or turn the TAD off. You hear
“Answer off.”
Press: To:
7 Skip to the previ-
ous message.
8 Repeat the cur-
rent message.
9 Skip to the next
message.
Stop message
playback.
0 twice within
2 seconds Delete the current
message.
43-728.fm Page 37 Thursday, August 26, 1999 8:53 AM