Radio Shack TAD-728 - Manual (Page 30)

30
2. Repeatedly press PREVIOUS or
SKIP on the base until the TAD
announces and displays the number
of rings you desire – “two” so the
TAD answers on the second ring,
“five” to answer on the fifth ring, or
“toll saver” when you want to use
the toll-saver function.
3. Press ANSWER or PLAY/REPEAT/
. The TAD sounds a long beep
and announces the selected num-
ber of rings. The TAD repeats the
selected number of rings or toll
saver every 3 seconds until 30 sec-
onds have passed.
Note: Press each button within 30 sec-
onds. If you take longer, the setting pro-
cedure is canceled automatically.
SETTING THE DAY
AND TIME
You must set the day and time so the
TAD can record the correct day and time
of each message.
1. If ANSWER is on, press STOP to turn
off the TAD.
2. Hold down STOP on the base until a
long beep sounds. The TAD
announces the day of the week.
CL
flashes on the digital display.
3. Press PREVIOUS or SKIP until the
TAD announces the correct day of
the week.
4. Press PLAY/REPEAT/ . The TAD
announces the hour and “AM” or
“PM.”
5. Press PREVIOUS or SKIP until the
TAD announces the correct hour,
including AM or PM.
6. Press PLAY/REPEAT/ . The TAD
announces the minute.
7. Press PREVIOUS or SKIP until the
TAD announces the correct minute.
Holding down PREVIOUS or SKIP
advances the minute rapidly and
announces minutes in 10 minute
increments. Release
PREVIOUS or
SKIP and the TAD announces the
minute setting. If you advance too
far when holding down
PREVIOUS or
SKIP , press the opposite button.
8. Press PLAY/REPEAT/ to enter the
minute setting. The TAD announces
the newly set day and time.
Notes:
• If you make an error, the TAD beeps
3 times. Repeat Steps 1–7.
• The TAD repeats the stage every 3
seconds for 30 seconds. After 30
seconds, the setting procedure is
canceled automatically.
• When you have an incoming call or
paging from the base while setting
the day and time, the setting proce-
dure is canceled.
A N SW ER
PLA Y/R EPEA T
SK IP
STO P
PR EVIO U S
D ELETE
43-728.fm Page 30 Thursday, August 26, 1999 8:53 AM