Radio Shack TAD-728 - Manual (Page 32)

32
2. When finished, press OGM REC
again (or press STOP ). The TAD
beeps, plays back the message,
then beeps again. The display
shows
A (or AO if you set it to
announcement-only), and the num-
ber of messages (if the TAD has
new messages) alternately. The
TAD is now ready to answer calls.
You can also record your message us-
ing the handset. Press
REMOTE . After
hearing the number of messages (or “no
messages”), follow these steps to record
your message.
1. Press OGM REC/1 twice within 2
seconds. A beep sounds. Then
speak your outgoing message into
the handset.
2. When finished, press OGM REC/1
again (or press STOP/HELP/
TONE ). The handset beeps, then
plays back the message.
SETTING THE TAD TO
ANSWER CALLS
To set the TAD to answer calls, press
ANSWER on the base. The TAD plays
the current outgoing message, then dis-
plays
A (or AO if set to announcement-
only). Press ANSWER again to choose
the prerecorded or your own message.
To turn off the TAD, press STOP except
while any message is playing back. The
TAD announces “Answer off.”
To turn the TAD on and off from the
handset, press
REMOTE so the handset
displays Remote . You hear the TAD
announce the number of currently re-
corded messages. Press
ANS/4 and the
TAD announces the current outgoing
message or “Answer off” (if it is off).
Repeatedly press
ANS/4 to turn the TAD
on, select between the prerecorded or
your own message, or turning the TAD
off.
Note: If the incoming message memory
is full (59 messages including your own
outgoing messages or less than 15 sec-
onds left), the TAD announces “No re-
maining time”,
F flashes on the digital
display. The TAD does not answer calls.
43-728.fm Page 32 Thursday, August 26, 1999 8:53 AM