Radio Shack TAD-728 - Manual (Page 12)

12
6. Plug the adapter into a standard AC
outlet. PF (power failure) flashes on
the display.
7. Lift the base’s antenna to a vertical
position.
Note: To mount the TAD directly on a
wall, you need two screws (not supplied)
with heads that fit into the keyhole slots
on the bottom of the base.
Follow the steps under “On a Wall Plate
or Wall” on Page 11, then apply these
additional instructions for placement on
a wall.
1. Drill two holes 3
15
/
16
inches (100 mm)
apart. Then thread
a screw into each
hole, letting the
heads extend about
3 /
16
inch (4 mm)
from the wall.
2. Plug one end of the supplied long
modular cord into the TEL LINE jack
on the back of the base.
3. Align the bracket’s keyhole slots
with the mounting screws and slide
the base downward to secure it.
CONNECTING AND
CHARGING THE
BATTERY PACK
The TAD-728 comes with a recharge-
able nickel-cadmium battery pack in the
handset but not connected. Before using
your phone, you must connect the bat-
tery pack, then charge it for about 12
hours.
1. Press down and slide off the battery
pack compartment cover.
2. Lift the battery pack out of the com-
partment.
3. Plug the battery pack's connector
into the socket in the compartment
(the connector fits only one way),
and route the battery pack's leads
through the strain relief slot, then
replace the battery pack.
Return
to cradle appears on the hand-
set display indicating loss of the
handset security access-protection
code. Returning the handset to the
base restores the security access-
protection code.
3 /
16
3 15 /
16
43-728.fm Page 12 Thursday, August 26, 1999 8:53 AM