RAD Data comm 4-Wire Symmetrical VDSL Modem ASM-60 - Manual (Page 76)

Appendix C IR-IP Interface Module ASM-60 Installation and Operation Manual
C-22 Device Control Menu
View Error Log Screen
This item of the Device Control submenu is used to view the error log file. This file
logs errors detected in IR-IP for debug and technical support purposes.
Resets Menu
The Resets menu allows you to perform reset of IR-IP, or its interfaces.
This operation can be used to restore normal operation after service is disrupted
by an abnormal condition. Any data stored in the IR-IP buffers is discarded, and
the flow of traffic is temporarily interrupted.
To access the Resets menu:
• From the Device Control menu, type 3.
The following screen appears:
IR_IP S/W Ver. 1.00 31/IR (date)
Quick Setup
Management Access
Advanced Setup
Device Control
.....................................................................
New Software Download
View error LOG
Resets
=====================================================================
1. Reset Device
2. Reset LAN
3. Reset WAN
Press one of the numbers to select or ESC:
Figure C-18. Resets Menu
Reset Device
To restart IR-IP:
• From the Resets menu, type 1.
You will be prompted to confirm the reset operation.
Resetting the device will restart the IR-IP interface module, and therefore traffic flow
is temporarily interrupted, and the Telnet connection is lost.
Reset LAN
To reset the LAN interface:
• From the Resets menu, type 2.
You will be prompted to confirm the reset operation.
This operation restarts the IR-IP LAN controller.
To continue your Telnet session, press any key within 15 seconds following the
confirmation of the reset operation.
Note
Note