Led indicators, Connecting to lan – RAD Data comm 4-Wire Symmetrical VDSL Modem ASM-60 User Manual
Page 50
Appendix A IR-ETH Interface Module
ASM-60 Installation and Operation Manual
A-4
Installation and Operation
LED Indicators
lists the IR-ETH LED indicators and describes their functions.
Table A-3. IR-ETH Bridge LED Indicators
LED
Name
Description Location
Color
LINK
ON – Good link integrity
Rear panel
Green
COLL
ON – Collision on the attached Ethernet
segment is detected
Rear panel
Yellow
RX
ON – Data is received from the Ethernet
attached segment
Rear panel
Yellow
TX
ON – Data is transmitted from the modem to
the Ethernet segment
Rear panel
Yellow
ERR D4
ON – Bridge buffer overrun is detected
IR-ETH board Red
Connecting to LAN
When connecting an IR-ETH interface module with the UTP option, use either a
straight cable or a cross cable for the LAN connection. Use a cross cable when
connecting to a port that does not implement the crossover function internally.
Otherwise, use a straight cable.
Hubs usually do implement the crossover function internally, while network
interface cards and other devices do not.
Note