Nikon NP64 User Manual

Page 82

6. Using On-Screen Menu

Selecting Power-saving in [STANDBY MODE]

The projector has two standby modes: [NORMAL] and [POWER-SAVING].
The POWER-SAVING mode is the mode that allows you to put the projector in the power-saving condition which
consumes less power than the NORMAL mode. The projector is preset for NORMAL mode at the factory.

NORMAL �� POWER indicator: Orange light/STATUS indicator: Green light
POWER-SAVING �� POWER indicator: Orange light/STATUS indicator: Off

The following connectors, buttons or functions will not work during this mode.
- PC CONTROL port
- Buttons other than POWER button on the cabinet
- Buttons other than POWER ON button on the remote control

NOTE:

• When [CONTROL PANEL LOCK], [CONTROL ID], or [AUTO POWER ON(COMP.)] is turned on, the [STANDBY MODE] setting is

not available.

• The power consumption in the standby mode will not be included in calculating CO

emission reduction.

• Your setting will not be affected even when [RESET] is done from the menu.

Enabling Auto Power On [AUTO POWER ON(AC)]

Turns the projector on automatically when the power cable is inserted into an active power outlet. This eliminates
the need to always use the POWER button on the remote control or projector cabinet.

Turning On the Projector By Applying RGB Signal [AUTO POWER ON(COMP.)]

When the projector is in Standby mode, applying an RGB signal from a computer connected to the COMPUTER
IN input will power on the projector and simultaneously project the computer’s image.
This functionality eliminates the need to always use the POWER button on the remote control or the projector
cabinet to power on the projector.
To use this function, first connect a computer to the projector and the projector to an active AC input.

NOTE:

• Disconnecting an RGB signal from the computer will not power off the projector. We recommend using this function in com-

bination of the AUTO POWER OFF function.

• This function will not be available under the following conditions:

- when a component signal is applied to the COMPUTER IN connector

- when a Sync on Green RGB signal or composite sync signal is applied

• To enable the AUTO POWER ON (COMP.) after turning off the projector, wait 3 seconds and input a computer signal.

If a computer signal is still present when the projector is turned off, the AUTO POWER ON (COMP.) will not work and the pro-

jector remains in standby mode.

Enabling Power Management [AUTO POWER OFF]

When this option is selected you can enable the projector to automatically turn off (at the selected time: 5min.,
10min., 20min., 30min.) if there is no signal received by the COMPUTER, VIDEO, or S-VIDEO input.