Projecting an image (basic operation) – Nikon NP64 User Manual
Page 26
17
3. Projecting an Image (Basic Operation)
SOURCE
AUTO
ADJ.
ON/STAND BY
FOCUS
LAMP
STATUS
POWER
SOURCE
AUTO
ADJ.
ON/STAND BY
FOCUS
LAMP
STATUS
POWER
Note on Startup screen (Menu Language Select screen)
When you first turn on the projector, you will get the Startup menu. The menu gives you the opportunity to select
the menu in one of the 21 languages.
To select a menu language, follow these steps:
1. Use the
▲, ▼, ◀ or ▶ button to select one of the 21
languages from the menu.
2. Press the ENTER button to execute the selection.
After this has been done, you can proceed to the menu op-
eration.
If you want, you can select the menu language later. (
→ [LAN-
NOTE:
• If one of the following things happens, the projector will not turn on.
- If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this condition
the projector will not turn on to protect the internal system. If this happens, wait for the projector’s internal components to
cool down.
- When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.
- If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute and then
turn on the power.
• The projector cannot be turned off with the ON/STAND BY button or the POWER OFF button while the POWER indicator is
flashing green in a cycle of 0.5 second on and 0.5 second off.
• Do not disconnect the AC power supply to the projector for 60 seconds immediately after turning it on and displaying an im-
age.
• Immediately after turning on the projector, screen flicker may occur. This is normal. Wait 3 to 5 minutes until the lamp light-
ing is stabilized.
• If you turn on the projector immediately after the lamp is turned off or when the temperature is high, the fans run without dis-
playing an image for some time and then the projector will display the image.