Installation and connections, 1) setting up the screen and the projector, Selecting a location – Nikon NP64 User Manual
Page 18: Setting up the screen and the projector
9
This section describes how to set up your projector and how to connect video and audio sources.
2. Installation and Connections
➊
Setting Up the Screen and the Projector
Selecting a Location
The further your projector is from the screen or wall, the larger the image. The minimum size the image can be is
33" (0.84 m) measured diagonally when the projector is roughly 57 inches (1.44 m) from the wall or screen. The
largest the image can be is 300" (7.6 m) when the projector is about 484 inches (12.3 m) from the wall or screen.
Use the chart below as a rough guide.
Your projector is simple to set up and use.
But before you get started, you must first:
➊
Set up a screen and the projector.
➋
Connect your computer or video
equipment to the projector. See pages
,
➌
Connect the supplied power cable.
See page
NOTE: Ensure that the power cable and any oth-
er cables are disconnected before moving the
projector. When moving the projector or when
it is not in use, cover the lens with the sliding
lens cover.
Distance (U
nit: m/inch)
Lens center
Screen Size (diagonal: inch)
Screen Size (Unit: cm/inch)
609.6(W)×457.2(H) / 240(W)×180(H)
487.7(W)×365.8(H) / 192(W)×144(H)
406.4(W)×304.8(H) / 160(W)×120(H)
365.8(W)×274.3(H) / 144(W)×108(H)
304.8(W)×228.6(H) / 120(W)×90(H)
243.8(W)×182.9(H) / 96(W)×72(H)
203.2(W)×152.4(H) / 80(W)×60(H)
162.6(W)×121.9(H) / 64(W)×48(H)
121.9(W)×91.4(H) / 48(W)×36(H)
81.3(W)×61.0(H) / 32(W)×24(H)
300"
240"
200"
180"
150"
120"
100"
60"
40"
80"
12.3/484.3
9.8/385.8
8.2/322.8
7.4/291.3
6.1/240.2
4.9/192.9
4.1/161.4
3.3/129.9
2.4/94.5
1.6/63.0
NOTE:
• The distances are indicated by intermediate values between tele and wide. Use as a rule of thumb.
• The Zoom lever adjusts the image size up to +/−10%
• For more details on throw distance, see next page.
• Changing the image size starts the AUTO FOCUS to adjust the focus; changing the throw angle starts the Auto Keystone to
correct the vertical keystone distortion.
To the wall outlet.