Nikon NP64 User Manual
Page 50
41
5. Using the Viewer (NP64/NP54)
❷
Projecting images stored in a USB memory device (Basic operation)
This section explains the basic operation of the Viewer.
The explanation provides the operational procedure when the Viewer [OPTIONS] menu (
→ page
) is set to the
factory default.
- Starting the Viewer ......................................................................below
- Removing the USB memory from the projector ...................... page
- Exiting the Viewer .................................................................... page
Preparation: Before starting the Viewer, store images to the USB memory using your computer.
Starting the Viewer
1. Turn on the projector. (
→ page
)
2. Insert the USB memory into the USB port of the pro-
jector.
- To remove the USB memory from the projector, select
“REMOVE USB DEVICE” from the OPTIONS menu. (
→
Step 5 on page
3. Press the
▶ (SOURCE) button.
The SOURCE list will be displayed.
• Another way to display the SOURCE list is to press the
VIEWER button on the remote control. Go on to Step [5].
4. Press the
▶ (SOURCE) three times to select the cur-
sor to [VIEWER].
Each time the
▶ button is pressed quickly, the next
source will be highlighted.
• During this time, do not press and hold the
▶ button for
2 seconds or longer. Doing so will start the projector to
detect the signal automatically.
Highlighting [VIEWER] for a while will start the Viewer to
project images stored in the USB memory (slide screen).