National Instruments Module SCXI-1125 - Manual (Page 33)

Chapter 3 Configuring and Testing
SCXI-1125 User Manual 3-8 ni.com
Complete the following steps to use channel strings in verifying the signal:
1. Expand Devices and Interfaces.
2. Expand Traditional NI-DAQ Devices.
3. Right-click the appropriate E Series DAQ device.
4. Click Test Panels.
5. Enter the channel string.
6. Enter the input limits.
7. Select the Data Mode.
8. Select the Y Scale Mode.
Refer to the LabVIEW Measurements Manual for more information and for
proper formatting of channel strings for different uses.
Verifying the Signal Using Virtual Channel
If you have already created a virtual channel, complete the following steps
to verify the signal:
1. Right-click the virtual channel you want to verify and select Test.
2. In Channel Names, select the channel you want to verify.
3. When you have completed verifying the channel, click Close.