National Instruments Module SCXI-1125 - Manual (Page 11)

Chapter 1 About the SCXI-1125
SCXI-1125 User Manual 1-2 ni.com
Note For maximum allowable voltage for a particular terminal block refer to Table A-2,
Terminal Block Maximum Voltages .
– SCXI or PXI/SCXI combination chassis
– One of the following:
• E/M Series DAQ device
• SCXI-1600 module
– A computer if using an SCXI chassis
– Cabling, cable adapter, and sensors as required for your
application
❑
Software
– NI-DAQ 7.0 or later
– One of the following software packages:
• LabVIEW
• LabWindows ™ /CVI ™
• Measurement Studio
❑
Documentation
– Read Me First: Safety and Radio-Frequency Interference
– DAQ Getting Started Guide
– SCXI Quick Start Guide
– SCXI-1125 User Manual
– Documentation for your hardware
– Documentation for your software
National Instruments Documentation
The SCXI-1125 User Manual is one piece of the documentation set for data
acquisition (DAQ) systems. You could have any of several types of
manuals depending on the hardware and software in the system. Use the
manuals you have as follows:
• SCXI or PXI chassis manual—Read this manual for maintenance
information on the chassis and for installation instructions.
• The DAQ Getting Started Guide—This document has information on
installing NI-DAQ and the E/M Series DAQ device. Install these
before you install the SCXI module.