Nortel Networks 5000i - Manual (Page 48)

4. Scanner Checkout
This chapter discusses the procedures for scanner checkout, pre-installed system software,
system verification and backup, and customer hand-off.
Scanner Checkout Procedures{ XE "Scanner,
5000i:Checkout procedures" }{ XE "Software
checkout" }
To checkout the 5000i scanner, refer to the following sections in the Maintenance Manual for the
5000i
® Scanner.
1. Hopper and Stacker Operational Checkout (Section 2.6)
2. Sensor Checkout Procedures (Section 2.8)
3. Read Station Adjustments (Section 3.2)
4. Check Alignment test (Section 5.2.4.8)
5. Hopper Height Adjustments (Section 3.5)
6. Pick Area Adjustments (Section 3.3)
7. Calibrating (and Normalizing) the Scanner (Section E.2)
System Software
5000i scanner system software is pre-installed at NCS Pearson. For information regarding this
software{ XE "Checkout:Software" }, refer to the following publications:
• Image ScanTools™ for 5000i
® Scanners - includes information on installation, setup, and
configuration. Error messages are not documented in this publication. Error messages are
displayed in On-Line Help.
• NCS Accra™ - includes information on installation, setup, and configuration. Error messages
are not documented in this publication; error messages are displayed on Online Help.
System Verification{ XE "Checkout:System
verification" }
This section describes how to update the 5000i scanner system software.
Requirements
You need to have an additional 90 to 100 MB of disk space if you intend to maintain a copy of the
old and new software.
Page 36 5000i Scanner Installation Guide