Nortel Networks 5000i - Manual (Page 18)

2. Scanner Installation
This chapter describes how to set up and install the standalone 5000i scanner{ XE
"Installation:Scanner" },{ XE "Scanner installation:Introduction" } the computer, the monitor, and
the mouse.
The 5000i scanner system consists of the following { XE "Scanner installation:Components"
}components.
• Model 5000i
• Computer
• SVGA monitor
• Duplex Heads (InfraRed/Red Ink—I/R--heads)
• Transport Printer (optional)
• Bar Code (optional)
Preparation
Before assembling{ XE "Scanner installation:Preparation" } the standalone 5000i scanner, check to
make sure that you have all the hardware and accompanying documentation as listed below.
Hardware
• Computer with SVGA monitor, keyboard, mouse, and furniture (standalone only)
Documentation: Manufacturer's user manuals
• A model 5000i image scanner with interface card and cable
Documentation: Operator's Guide for the 5000i ® Scanner and the Maintenance Manual for the
5000i ® Scanner
• Normalization and Calibration forms packet
Documentation: Operator's Guide for the 5000i Scanner
Software
• Microsoft ® Windows NT ® software
Documentation: NT User Guide
• Scanner application software
Documentation: Image ScanTools™ User's Guide
• Scanner Exerciser diagnostic software (or equivalent)
Documentation: Operator's Guide for the 5000i and Maintenance Manual for the 5000i ®
Scanner
Page 6 5000i Scanner Installation Guide