Nortel Networks 5000i - Manual (Page 21)

Installing the Scanner
The 5000i scanner is delivered to the customer shrink-wrapped and up-right on its own four
casters. Roll the scanner to its permanent location.
Unpacking the Scanner
To unpack { XE "Scanner installation:Unpacking" }{ XE "Unpacking the scanner, procedure" \t
"See" }the scanner, do the following:
1. Remove the clear vinyl dust cover.
Do NOT throw the clear vinyl dust cover away. It can be used to protect the scanner
• during periods of non-use, or
• when moving to another location.
2. Remove the clear plastic shrink-wrap.
3. Remove the packing materials (sheets of paper) located
• on the transport bed,
• on the hopper tables, and
• between the read head glass.
4. Remove the packing materials (blocks of styro-foam) located
• between the printer deck and printer cover (holds the printer cover in place), and
• between the sliding tray for the PC and interior bulkhead (prevents the PC tray from
sliding during shipping).
Spares{ XE "Spares kit, contents" }
A separate box of { XE "Scanner installation:Spares" }spares is provided with each scanner. This
includes the following:
• Retard pads
• Pick belts
• Manuals
• A key for the front panel door
For safekeeping, place the key in the hole located below the printer deck and to the left
of the printer cover. Keep the spare retard pads and pick belts in a safe place such as
on the computer shelf inside the scanner cabinet. These spares are used as
replacements (See the Operator's Guide for the 5000i Scanner for instructions on
removing/replacing retard pads and pick belts).
Chapter 2. Scanner Installation Page 9