Nortel Networks 5000i - Manual (Page 34)

• Attach one end of the Hobbes to Catgut cable assembly (flat, 40-pin polarized cable)
to the Hobbes board{ XE "Hobbes board" \i }.
• Set the Catgut board into the PCI slot—two slots to the right of th Hobbes board—
making certain that the Catgut board (and the Hobbes board) are firmly seated.
• Attach the other end of the Hobbes to Catgut cable to the Catgut board.
4. Ensure that the high density ribbon cable connector connecting the Hobbes board to the
Catgut board is fully seated.
5. Replace the cover on the computer.
6. Open the rear panel doors and place the computer on the shelf. The front of the
computer must face the front of the scanner.
Cabling
In preparation for{ XE "Standalone installation:Cabling" } cabling, NCS Pearson recommends
that you do the following:
• Set the computer on the back lip of the shelf during cable installation so that the back of
the computer is tilted up. This provides easier access to the computer's ports.
• Uncoil all cords and cables, separate them, and lay them out on the floor.
The following cabling instructions are for a standalone configuration{ XE
"Cabling:Standalone configuration" }. Refer to Figures 3-4 and 3-5, and Table 3-1 at the end of
this chapter.
1. Install the computer power cord.
• Attach the power cord connector to the back of the computer.
• Ensure that the other end is plugged into the scanner's power strip.
2. Complete installation of the 25-pin straight through cable - the PRTCON board (for the
optional printer) to the back of the computer.
• One end of this cable is already attached to the PRTCON board.
• Connect the other end (free end) to the back of the computer.
3. Complete installation of one 6-pin DIN cable - the KEMCON board (for the keyboard)
to the back of the computer.
• One end of this cable is already attached to the KEMCON board.
• Connect the other end (free end) to the back of the computer in the keyboard port.
4. Complete installation of the other 6-pin DIN cable - the KEMCON board (for the mouse)
to the back of the computer.
• One end of this cable is already attached to the KEMCON board.
• Connect the other end (free end) to the back of the computer in the mouse port.
5. Complete installation of the 5 BNC/15-pin DIN cable - from the bulkhead (for the
monitor) to the back of the computer.
• One end (5 BNC end) is already attached to the bulkhead.
• Connect the other end (15-pin DIN) to the back of the computer.
Connect this cable to the 15-pin connector on the video card in the first expansion
Page 22 5000i Scanner Installation Guide