NetComm IP DSLAM NCT480 - Manual (Page 50)

NCT480 IP DSLAM User Guide YML856 Rev3
50 www.netcomm.com.au
DSL Status
The line status shows the ADSL line information.
Figure 3-1 DSL Status Dialog
Item Description
Port selection menu Select the ADSL port interface to be display with relative parameters.
Operation state Operational state of the DSL port.
Current status Indicates current state of the DSL line. This is a bit-map of possible conditions.
Operation mode Operation mode used by the DSL port.
Actual standard Actual standard used for connection, based on the outcome of the negotiation with the
ATU-R
Attain rate (bps) Indicates the maximum currently attainable data rate by the ATU-x. This value will be
equal to, or greater than the current line rate.
Attenuation (1/10 db) Measured difference in the total power transmitted by the peer ATU-x and the total
power received by this ATU-x.
Current SNR (1/10 db) Noise Margin as seen by this ATU-x with respect to its received signal in tenth dB.
Output power (1/10 dbm) Measured total output power transmitted by this ATU-x. This is the measurement that
was reported during the last activation sequence.
Rate (bps) Actual transmit rate on this channel.
Interleave delay (ms) Interleave delay for this channel.
Block length (byte) Indicates the length of the channel data-block, on which the CRC operates.
Table 3-1 DSL Status Dialog Description