Navman 5380 - Manual (Page 53)

TRACKER 5380 Installation and Operation Manual 53 NAVMAN
Selecting an antenna
Fit one of these GPS antennas:
• Normally use the internal GPS antenna
(TRACKER5380i) or the GPS antenna
supplied (TRACKER 5380).
• An optional differential beacon DGPS
antenna to give enhanced accuracy within
range of land based differential beacons
in areas where WAAS or EGNOS are not
available. Such a DGPS antenna has both
a GPS receiver and a beacon receiver,
and it automatically applies the beacon
correction to the GPS position.
• A compatible GPS or DGPS instrument or
antenna connected by NavBus (see section
15-8) or NMEA (see section 15-9). In this
case, the TRACKER does not need its own
antenna.
Note:
• The TRACKER can apply the WAAS and
EGNOS DGPS correntions to any GPS
antenna.
• To configure the TRACKER for different
antenna options, see section 14-3.
For more information, contact your NAVMAN
dealer.
Installing an antenna
If an external antenna is required, install the
antenna and fit the antenna cable back to
the display unit. Follow the instructions in
the manual supplied with the antenna. Fit an
optional Navman extension cable if required.
Connect the TRACKER 5380 external antenna to
the gold TRACKER connector:
Fit the optional petrol/gasoline fuel kit
following the instructions supplied with
the kit.
Note:
SmartCraft engines have fuel flow sensors,
therefore Navman fuel sensors are not
required as well.
For dual engines, fit two kits.
Wire the TRACKER for auto power (see
section 15-4).
During setup:
a set up Auto power off (see sections 2-3
and 17-1)
b set the fuel data (see section 14-4)
Fuel sensor cable
White
15-5 Installation: GPS antenna
15-6 Installation: NAVMAN petrol/gasoline sensors