Navman 5380 - Manual (Page 31)

TRACKER 5380 Installation and Operation Manual 31 NAVMAN
9 Data display
The data display has large numeric data fields.
To go to the data display, press
, select
Other, then select Data.
To select what data is displayed:
1 Press and select Data setup.
2 Change a data field:
i Press the cursor keys to highlight the
field.
ii Press to display a menu of data
items.
iii Select a data item that is available on
your system or select None to leave
the field empty.
3 Repeat the above step to set the other data
fields.
4 Press .
10 Fuel functions and display
The Fuel functions require optional fuel sensors to be installed.
10-1 When you add or remove fuel
When you add or remove fuel in a boat with no
SmartCraft fuel tank level sensors, you must
tell the TRACKER, otherwise
REMAINING,
RANGE and the low fuel alarm will be
meaningless.
A When you completely fill the tank
1 Fill the tank.
2 Press one or more times until the
Setup menu is displayed, then select
Fuel.
3 Select Tank full.
Note: Underfloor fuel tanks are often difficult
to refill to the same level twice, due to air
pockets. With underfloor fuel tanks:
Trim the boat to the same angle in the
water each time you follow procedure A.
Mostly use procedure B below when
adding fuel, but completely fill the tank
and follow procedure A about every tenth
time you add fuel.
B When you part fill the tank
1 Before adding fuel, go to the fuel display
and write down the value of Remaining, which
is the amount of fuel now in the tank.
2 Add fuel to the tank, writing down how
much you add.
3 Add together the two figures you have
written down, to calculate the amount of
fuel now in the tank.
4 Press one or more times until the
Setup menu is displayed, then select
Fuel.