Navman 5380 - Manual (Page 48)

TRACKER 5380 Installation and Operation Manual 48 NAVMAN
Press once or more until the Setup
menu is displayed, then select Calibrate:
Fuel
See section 14-4.
Speed range
The maximum reading to display on an analog
boat speed gauge (see section 10). Choose a
range suitable for your boat.
Max fuel flow
The maximum fuel flow from the fuel tank.
Simulate mode is a way of becoming familiar
with the TRACKER (see section 2-7).
Press once or more until the Setup
menu is displayed, then select Simulate:
Simulate
Turn simulate mode off
Turn simulate mode on
Warning: Never have simulate mode
on when the TRACKER is navigating on
the water.
Mode
There are two choices for Mode:
1 Normal
Simulates the boat moving from the selected
start point at the given speed and heading. The
options required for Normal are:
Speed : The simulated boat speed to use.
Course : The simulated bearing for the boat
to follow.
Note: To select the start point, go to the chart
display before starting the simulation. Then:
• To start the simulation from the boat
position, press
to switch to centre on
boat mode.
• To start the simulation from a different
point, move the cursor to that point on the
chart.
Tip: To calculate a course, use the cursor
(see section 3-3).
Press once or more until the Setup
menu is displayed, then select Time:
Local offset
The difference between local time and UTC
(GMT). Change local offset when daylight
saving time starts and ends. The range is 0 to ±
13 hours, in 30 minute steps.
Time format
The options are 24 hour or 12 hour.
Date format
The options are dd/MMM/yy, MMM/dd/yy,
dd/MM/yy or MM/dd/yy.
14-10 Setup > Calibrate
14-11 Setup > Time
14-12 Setup > Simulate