NetComm G.SHDSL 4-port Security Modem Routers NB712 - Manual (Page 97)

NB712 / NB714 User Guide 97
YML829 Rev1
14.16.3 WAN
The router supports up to 8 PVCs, private virtual circuits, and so you can setup up to 8 WANs; WAN1 to WAN8.
Move the cursor “ >> “ to wan and press enter. To setup WAN1, type 1.
----------------------------------------------------------------------
Command: setup wan <1~8>
Message: Please input the following information.
Interface number <1~8>: 1
----------------------------------------------------------------------
>> protocol Link type protocol
address IP address and subnet mask
vpi_vci Configure VPI/VCI value
encap Configure encapsulation type
qos Configure VC QoS
isp Configure account name, password and idle time
ip_type Configure IP type in PPPoA and PPPoE
list WAN interface configuration
There are four types of protocols, IPoA, EoA, PPPoA and PPPoE, which you can setup.
For dynamic IP of PPPoA and PPPoE, you do not need to setup the IP address and subnet mask.
There is an unique VPI and VCI value for Internet connection supported by ISP. The range of VIP is from 0 to 255
and VCI from 0 to 65535.
There are two types of encapsulation types, VC-Mux and LLC.
You can setup virtual circuit quality of service, VC QoS, using qos command. The product supports UBR, CBR,
VBR-rt and VBR-nrt. The peak cell rate can be configured from 64kbps to 2400kbps. Move the cursor to qos and
press enter.
>> class Configure QoS class
pcr Configure peak cell rate (kbps)
scr Configure sustainable cell rate (kbps)
mbs Configure max. burst size (cell)
ISP command can configure account name, password and idle time. Idle time can be from 0 minute to 300
minutes.
Most ISPs use dynamic IP for PPP connection but some will use static IP. Configure the IP type, dynamic or fixed,
via ip_type command.
You can review the WAN interface configuration via the list command.