5 connecting your g.shdsl modem router – NetComm G.SHDSL 4-port Security Modem Routers NB712 User Manual

Page 16

NB712 / NB714 User Guide

YML829 Rev1

5 Connecting your G.SHDSL Modem Router

This guide is designed to lead users through the Web Conﬁguration of the G.SHDSL Modem Router in the easiest
and quickest way possible. Please follow the instructions carefully.

Note:

There are three methods to conﬁgure the router: serial console, Telnet and Web
Browser. Only one conﬁguration application is used to setup the Modem Router at
any given time. Select the method you wish to use and continue.

For Web conﬁguration, you can skip step 3.

For Serial Console Conﬁguration, you can skip step 1 and 2.

Step 1: Check the Ethernet Adapter in PC

Make sure that an Ethernet Adapter has been installed in the PC that is to be used for conﬁguration of the router.
TCP/IP protocol is necessary for web conﬁguration, so please check that the PC has TCP/IP protocol installed.

Step 2: Check the Web Browser in PC

For Web Conﬁguration, ensure that the PC has a Web Browser installed, such as IE or Netscape.

Note: Suggest IE5.0, Netscape 6.0 or above and 800x600 screen resolution or above.

Step 3: Check the Terminal Access Program

For Serial Console and Telnet Conﬁguration, users need to setup the terminal access program with VT100
terminal emulation.

Step 4: Determine Connection Setting

Users need to know the Internet Protocol supplied by your Service Provider and determine the mode of setting.

Protocol

Selection

RFC1483

Ethernet

over

ATM

RFC1577

Classical Internet Protocol over ATM (CLIP)

RFC2364

Point-to-Point Protocol over ATM (PPPoA)

RFC2516

Point-to-Point Protocol over Ethernet (PPPoE)

Different Protocols are required to setup different WAN parameters. Your ISP will advise the correct protocol and
the necessary WAN parameters to conﬁgure your Modem Router.

This manual is related to the following products:

G.SHDSL 4-port Security Modem Routers NB714