NETGEAR ADSL2+ Modem Router DM111PSPv2 User Manual
Page 60
ADSL2+ Modem Router DM111PSPv2 User Manual
5-2
Advanced WAN Configuration
v1.0, December 2008
The following table describes the settings on the WAN Setup screen.
Table 5-1. WAN Setup
Field
Description
PVC Name
Connect
hyperlink
Connection link name.
Click the Connect hyperlink to connect to the WAN.
VPI/VCI
The VPI/VCI settings (see
for an explanation of these
settings).
Category
UBR (Unspecified Bit Rate), a guaranteed QoS for ATM networks.
Protocol
PPPoE LLC/SNAP (Logical Link Control/Sub Network Access Protocol).
NAT (Net Address
Translation)
NAT automatically assigns private IP addresses (10.1.1.x) to LAN-connected
devices.
• On. NAT is enabled.
• Off. NAT is disabled. Disable NAT only if you are sure that you do not require
it. For example, if the modem router is on the same network as a router that is
using NAT.
QoS (Quality of Service)
The modem router supports QoS applications. See
WAN IP Address
The method that the ISP uses to assign the WAN IP address. If your ISP assigns
private IP addresses, your private WAN IP address is shown here. Otherwise the
setting is Auto assigned.
MTU
The MTU (Maximum Transmit Unit) value set in the LAN IP screen. See
.
Edit
Icons that enable you to edit (the pencil icon) or delete (the waste bin icon) the
WAN connection.
Add
button
For adding a Permanent Virtual Connection (PVC) to the WAN. See the
following section.