NETGEAR ADSL2+ Modem Router DM111PSPv2 - Manual (Page 21)

ADSL2+ Modem Router DM111PSPv2 User Manual
Configuring Your Internet Connection 1-7
v1.0, December 2008
2. To bypass the Setup Wizard, select No, and then click Next. The Quick Setup screen displays:
3. Enter the settings in each Quick Setup screen. These settings are described in Table 1-2 .
4. Click Finish to save the settings and reboot the modem router.
The following table describes the settings for the Quick Setup screens.
Figure 1-5
Table 1-2. Quick Setup Screen Settings
Screen Name Settings
Quick Setup Enter the following settings:
• VPI. The Virtual Path Identifier (VPI) identifies the virtual path
between endpoints in an ATM network. The valid range is from 0 to
255.
• VCI. The Virtual Channel Identifier (VCI) identifies the virtual channel
endpoints in an ATM network. The valid range is from 32 to 65535
(1 to 31 is reserved for well-known protocols).
Configure Internet Connection-
Connection Type Enter the following settings. For information about these settings, see
Table 5-3 on page 5-4 .
• Protocol
• Encapsulation Type
Configure Internet Connection-
WAN IP Settings Enter the following settings. For information about these settings, see
Table 5-1 on page 5-2 .
• Obtain IP Address Automatically
• WAN IP Address
• Enable NAT
• MTU