NEC DS1000 - Manual (Page 58)

To place a call using a line or loop key:
1. Press the key.
The key will light green and you’ll hear dial tone
from your outside line.
If you have Store and Forward enabled and are
using a loop key, the system will dial out your call 6
seconds after you dial the last digit. To avoid wait-
ing, dial # after dialing your last digit.
You may have a Private Line that is only on your
phone. Check with your Communications Manager.
2. Dial the outside number you want to call.
Toll Restriction may prevent you from dialing cer-
tain outside numbers.
If you use a dial pulse line and wait 6 seconds
after dialing a digit, the system outdials any remain-
ing digits as tone (DTMF).
50
Central Office Calls, Placing
80000mfh08-01.qxd 12/10/04 3:20 PM Page 50