NETGEAR XE104 - Manual (Page 23)

XE104 User Guide
Installing the XE104 Wall-Plugged Ethernet Switch 3-9
v1.0, September 2005
7. The InstallShield Wizard will indicate the program is ready to install.
Click the Install button to trigger the installation.
8. When the installation is complete, click the Finish button.
Set Your Network Password
The fastest and most reliable way to set the network password is to set the password for all devices
at once. To do this, you need the device password recorded on the back label of each of the remote
PowerLine devices. There are two general steps to setting the password: first enter the device
password for each remote PowerLine device, and the set the network password.
1. Enter the device password for each remote PowerLine device:
a. Make sure that all PowerLine devices are plugged into 110 V AC wall sockets.
Figure 3-10