Nikon 9000ED User Manual

Page 41

Step 4 — Insert the Holder

Check the status LED
Make sure that the status LED is glowing
steadily. Do not insert fi lm holders while
the status LED is blinking.

Find the arrow on the front of the holder
The front each holder is marked with
an embossed arrow showing the direc-
tion of insertion. When the holder is
inserted, the side with the arrow should
face up with the arrow pointing toward
the scanner.

Calibration

The scanner is automatically calibrated at regular intervals if left on with no holder in place. Calibration
will end when a holder is inserted.

Arrow

Insert the holder
Keeping the holder straight, slide the it
into the holder slot with the arrow up
and facing toward the scanner. Once
the holder has been inserted as far as the
insertion guides, the automatic loading
mechanism will activate. Remove your
hands from the holder when loading
starts. When loading stops, the holder
is in scanning position.

Inserting Holders

If the loading mechanism is does not ac-
tivate, remove the holder and try again.
Do not use force. Once loading has
begun, do not interfere with the load-
ing mechanism. Attempting to remove
the holder during loading or otherwise
interfering with the mechanism could
cause scanning errors.

Insertion guide