Nikon 9000ED User Manual
Page 36
27
2.3
Insert masking sheets
When scanning a single strip or strips
of different lengths, place the fi lm at
the left end of the holder and cover
any open apertures with the supplied
masking sheets, cutting the sheet to the
appropriate length if necessary. When
scanning a single strip, place the fi lm in
the bottom row and the masking sheet
in the top row.
Masking sheet
When scanning two strips of equal
length, place the fi lm at the left end
of each row. Masking sheets are not
required.
2.4
Position the fi lm
Close the holder without latching it,
and check that the fi lm is correctly
aligned. If necessary, insert a pen
or other pointed object into the per-
forations and slide the fi lm until the
frames are aligned with the apertures.
The perforations can be accessed
through the cutouts at the left end of
the holder.
Positioning Film
Care should be taken to avoid damaging the perforations when positioning the fi lm.
Do not attempt to position the fi lm while the holder is latched. Failure to observe
this precaution could damage the fi lm.
2.5
Latch the holder
Press the holder closed until the
latches click into place. Proceed to
“Step 3
—
Open the Scan Window”
(
30).
Cutouts