Nikon 9000ED - Manual (Page 35)

26
2 Place fi lm in the holder
FH-835S Holder for 35-mm Film
The FH-835S can be used with one or two strips of 35-mm fi lm. Each strip can be up to
six frames long.
2.1
Open the holder
Insert your fi ngers through the holes
in the bottom half of the holder and
undo the latches, then open the
holder.
Latches
2.2
Insert fi lm
Place fi lm in the holder with the refl ec-
tive fi lm base up and the matte emulsion
surface down.
Inserting Film
Align the fi rst frame in each strip with
an aperture at the left end of the hold-
er. Leaving the apertures at the left
end of the holder uncovered or cover-
ing them with a masking sheet could
cause scanning errors or interfere with
accurate color reproduction.
Use only one type of fi lm; do not mix
negatives with positive fi lm.
Inserting Film
Do not place fi lm or masking sheets so that they protrude from the holder or overlap the fi lm guides.
Failure to observe this precaution could cause the holder to jam in the scanner.
“Film Base”/”Emulsion Surface”
When fi lm is examined under bright light, the image on the emulsion surface will be in slight relief, with
bumps and hollows where the image has been developed. The opposite surface (the fi lm base) will be
refl ective and smooth. Insert fi lm with the base up.
Direction of
insertion
Thumbnails
displayed in
order shown
Arrow