Nortel Networks T7406 - Manual (Page 20)

20 Chapter 1 About your T7406 Phone
NN40110-300 NN40110-300
11 Within 15 seconds, press and hold the OK button for five seconds. This sends the Security Code
to the base station. The display shows Send OK! and you hear a beep when the transfer is
successful.
12 If the Security Code transfer fails, the display shows Send Error! To correct this, repeat steps 9
and 10.
13 Press the Options button to exit the Option menu.
The display changes to show the date and time.
Configure the next handset to the base station
Configure the second and third handsets to the base station using these procedures:
1 Follow the steps in “Configuring the Handset ID Number” on page 18 . Ensure you enter a
different handset ID number (1, 2, or 3) for each handset you configure.
2 If you want to change the handset ID password, continue with the steps in “Changing the
Handset ID Password” on page 18 .
3 Once you have assigned a Handset ID #, continue with “Assigning the Security Code” on page
19 up to and including step 8
To configure the next handset:
1 Find out the existing Security Code of the base from your installer.
2 Press the Options button.
3 Press SHOW .
The display shows 1. Set S.S. Code : .
4 Press SHOW .
The display shows Press 6 digits .
5 Enter a six-digit Security code.
The display changes to show the code as entered.
6 Press OK to accept the code.
7 Press NEXT until the display shows 3. Handset ID .
8 Press SHOW .
The display shows Press Digits 1-3 .
9 Press 1 , 2 , or 3 .
10 Press OK to accept the handset configuration.
11 Press the Options button.
The display changes to show the date and time.