NETGEAR GA311 - Manual (Page 36)

NETGEAR 10/100/1000 Mbps Gigabit Ethernet Adapter GA311 User Manual
3-6
v1.0, February 2007
• Try inserting the network adapter in another slot. If the new position works, the original slot in
your system may be defective.
• Replace the failed network adapter with one that is known to work properly. If the second
adapter works in the slot where the first one failed, the original adapter is probably defective.
• Install the network adapter in another functioning system and run the tests again. If the adapter
passed the tests in the new system, the original system may be defective.
• Remove all other network adapters from the system and run the tests again. If the adapter
passes the tests, the other adapters might be causing the conflict.
Table 3-3. PCI BIOS Parameters
Parameter Setting
Bus-Master Enabled
Interrupt
number Set to any IRQ that does not conflict with another device
Latency timer Recommended range is between 20 and 255. This parameter is typically
set to 64