NETGEAR DG834GV v2 - Manual (Page 82)

Reference Manual for the Integrated ADSL Modem and Wireless Router with Voice, Model
7-6 Advanced Configuration
v1.0, September 2006
• RIP Direction
RIP (Router Information Protocol) allows a modem router to exchange routing information
with other routers. The RIP Direction selection controls how the Modem Router sends and
receives RIP packets. Both is the default.
— When set to Both or Out Only, the modem router will broadcast its routing table
periodically.
— When set to Both or In Only, it will incorporate the RIP information that it receives.
— When set to None, it will not send any RIP packets and will ignore any RIP packets
received.
• RIP Version
This controls the format and the broadcasting method of the RIP packets that the modem
router sends. It recognizes both formats when receiving. By default, this is set for RIP-1.
— RIP-1 is universally supported. RIP-1 is probably adequate for most networks, unless you
have an unusual network setup.
— RIP-2 carries more information. Both RIP-2B and RIP-2M send the routing data in RIP-2
format.
– RIP-2B uses subnet broadcasting.
– RIP-2M uses multicasting.
DHCP
By default, the modem router will function as a DHCP (Dynamic Host Configuration Protocol)
server, allowing it to assign IP, DNS server, and default gateway addresses to all computers
connected to the modem router's LAN. The assigned default gateway address is the LAN address
of the router. IP addresses will be assigned to the attached PCs from a pool of addresses specified
in this menu. Each pool address is tested before it is assigned to avoid duplicate addresses on the
LAN.
For most applications, the default DHCP and TCP/IP settings of the router are satisfactory. See
“Internet Networking and TCP/IP Addressing” in Appendix B for an explanation of DHCP and
information about how to assign IP addresses for your network.
Use Router as DHCP server
If another device on your network will be the DHCP server, or if you will manually configure the
network settings of all of your computers, clear the ‘Use router as DHCP server’ check box.
Otherwise, leave it selected.