Philips SE140 - Manual (Page 28)

26
4 You can now adjust the
dial mode or press to
return to standby.
6.4 Dial mode
The default SE140 dialling mode
is suitable for your country and
network. It is unlikely that you
should need to change this setting.
1 Press four times.
The display shows -1- or
-2- .
2 Press or to switch
between 1 = Tone and
2 = Pulse.
3 Press to save the settings.
4 You can now adjust the
recall mode, see below,
or press
to return to
standby.
6.5 Recall mode
The button is used with
certain network services and
PABX*/switchboard services.
You will not normally need
to change this setting unless
advised to do so.
Note
The use of your SE140 cannot
be guaranteed on all PABX.
1 Press fi ve times.
The display shows FLASH
and the current setting
2 Press or to switch
between 1 (Flash 1 with Time
break recall, or 2 (Flash 2
with Time break recall).
3 Press to save the settings.
4 You can now adjust Auto-
prefi x or press to
return to standby.
6.6 Auto-prefi x
You can set the SE140 to detect
a dialling number and replace it
with another number. The total
of both numbers together can
be up to a maximum of 24 digits.
1 Press six times.
The display shows (
-------
-----
).
2 In the fi rst set of spaces,
enter the number you want
to be detected (max. 4 digits).
Press or to move
the cursor.
Personal settings
SE140_UK_IR_Index 2_Internet_08.10.07.indd Sec1:26 SE140_UK_IR_Index 2_Internet_08.10.07.indd Sec1:26 08.10.2007 11:39:57 08.10.2007 11:39:57