Panasonic PT-AE1000U - Manual (Page 32)

PICTURE Menu
32 - E NGLISH
Settings
You can switch automatic adjustment of the lamp and
the lens iris on/off.
• ON: Automatic adjustment
• OFF: No adjustment
You can monitor whether or not the luminance level of
the input signal is in the recommended range by
displaying it in the waveform monitor. If the waveform is
not in the range, adjust it for the best quality. See
“Adjusting the waveform of the input signal” on page 24.
1. Press F G to move to the required waveform
style.
2. Press ENTER to select.
The WAVEFORM MONITOR will be
displayed.
3. Adjust the WAVEFORM MONITOR.
See “Adjusting the waveform of the input
signal” on page 24.
From the ADVANCED MENU, you can perform more
detailed image adjustment manually.
J GAMMA
You can adjust linear intensity at 3 levels. Press
I H to increase/decrease 1 point.
Setting range: -8 to +8
J CONTRAST
You can adjust the amount of contrast in RGB
colors individually. Press I H to
increase/decrease 1 point.
Setting range: -32 to +32
J BRIGHTNESS
You can adjust the brightness in RGB colors
individually. Press I H to increase/decrease
1 point.
Setting range: -16 to +16
J COLOR MANAGEMENT
You can manage your own defined color settings.
See “Setting your own color profile” on page 26.
J NR (Noise Reduction)
You can switch the automatic noise reduction
system on/off. Press I H to select the required
setting.
• ON:
Automatic noise reduction
• OFF: No noise reduction
DYNAMIC IRIS
WAVEFORM MONITOR
OFF
FULL SCAN(Y)
FULL SCAN(R)
FULL SCAN(G)
FULL SCAN(B)
SINGLE LINE SCAN(Y)
SINGLE LINE SCAN(R)
SINGLE LINE SCAN(G)
SINGLE LINE SCAN(B)
MONITOR POSITION UPPER LEFT
ADVANCED MENU
Levels Default setting
GAMMA HIGH 0
GAMMA MID 0
GAMMA LOW 0
RGB Default setting
CONTRAST R 0
CONTRAST G 0
CONTRAST B 0
RGB Default setting
BRIGHTNESS R 0
BRIGHTNESS G 0
BRIGHTNESS B 0
NOTE:
Applying noise reduction may affect image quality.
PT-AE1000U.book Page 32 Monday, October 16, 2006 1:40 PM