Panasonic PT-DW90XE - Manual (Page 77)

PROJECTOR SETUP menu
ENGLISH -
77
Settings
COOLING CONDITION
You can control the fan speed for projecting
angle. When the projector is angled, [COOLING
CONDITION] setting must be set correctly. Failure to
observe this may result in malfunctions, or the life of
the lamp or the other components may be shortened.
Press ▲▼ to select [COOLING 1 )
CONDITION].
Press button.
2 )
The [COOLING CONDITION] screen will be z
displayed.
Press ▲▼ to select cooling condition. 3 )
Press button. 4 )
When the confirmation message is 5 )
displayed, select [OK] or [CANCEL].
LAMP SELECT
You can select a lamp lighting pattern for using
environment.
Press ▲▼ to select [LAMP SELECT]. 1 )
Press ◄► to switch [LAMP SELECT]. 2 )
The setting will change as follows each time z
◄► is pressed.
DUAL SINGLE
LAMP2 LAMP1
DUAL All lamps will light.
SINGLE
Selects a lamp with shorter duration
of use.
LAMP1 Selects the Lamp unit 1.
LAMP2 Selects the Lamp unit 2.
Press button. 3 )
Note
If, in the [SINGLE], [LAMP1] or [LAMP2] mode, one lamp z
remains off or the currently active lamp exceeds 3 000
hours of cumulative operating time (when [HIGH] is
selected as the [LAMP POWER] setting), the other lamp
will light.
If, in the [DUAL] mode, one lamp remains off or the
currently active lamp exceeds 3 000 hours of cumulative
operating time (when [HIGH] is selected as the [LAMP
POWER] setting), the other lamp alone will light.
However, if both lamps remain off or the 3 000 hours of
cumulative operating time (when [HIGH] is selected as
the [LAMP POWER] setting) are exceeded, the projector
will enter the standby mode.
The colors of the items indicate the status. z
Green→Current setting
Yellow→Current setting
(when a lamp fails or fails to light)
Red→Lamp that has failed to light
White→Any other status
If the projector is repeatedly used for short periods of z
time, the lamps will need to be replaced more frequently.
LAMP RELAY
If using the projector for a continuous period of
24 hours or more, this setting can be used to
automatically switch the lamps that are turned on in
order to reduce the lamp deterioration that can occur
as a result of continuous use.
Press ▲▼ to select [LAMP RELAY]. 1 )
Press button. 2 )
The [LAMP RELAY] screen is displayed and the z
adjustment mode (flashing) is activated.
Press ◄► to select [HOUR] or 3 )
[MINUTE] and use ▲▼ to adjust the
time.
Press button.
4 )
The lamp relay is set to the selected time. z
OFF Û 00 : 00
00 : 59 00 : 01
When setting the [MINUTE], irrespective of the : Û
set value for [HOUR], please adjust and set in the
following order of 59 minutes, [OFF], 00 minutes.
CEILING
SETTING
30°
30°
VERTICAL DOWN
SETTING
30°
30°
VERTICAL UP
SETTING
FLOOR
SETTING
(Unit: 1 hour or
1 minute)