Panasonic PT-DW90XE - Manual (Page 61)

POSITION menu
ENGLISH -
61
Settings
Press ▲▼ to select [INTERLOCKED]. 3 )
Press ◄► to switch [INTERLOCKED]. 4 )
OFF
The [VERTICAL] and
[HORIZONTAL] settings are used
as the vertical and horizontal zoom
ratios respectively.
ON
The zoom ratio is set to the [BOTH]
setting.
This allows the pictures to be
zoomed at equal vertical and
horizontal ratios.
Note
When [ASPECT] is set to [THROUGH], [ZOOM] will not z
appear.
When other than [DEFAULT] is selected for [ASPECT], z
the [MODE] selection setting will not appear.
CLOCK PHASE
Clock phase adjustment achieves the best image
when the screen flickers or halos are observed around
contours.
Press ▲▼ to select [CLOCK PHASE]. 1 )
Press ◄► or button. 2 )
The [CLOCK PHASE] individual adjustment z
screen will be displayed.
Press ◄► to adjust the level. 3 )
The value changes from 0 to 63. Adjust so that z
the amount of interference is at a minimum.
Note
The CLOCK PHASE may not be adjusted, depending on z
the signal.
No optimal value may be obtained if the output of the PC z
to which the signal input is applied is unstable.
No optimal value may be obtained if the total number of z
dots is not correct.
The [CLOCK PHASE] can be adjusted only when RGB z
signal input is applied with RGB1 and RGB2 IN.
GEOMETRY
(PT-DZ110XE/PT-DS100XE only)
Square video can be projected onto a special shaped
screen using unique image processing technology.
Press ▲▼ to select [GEOMETRY]. 1 )
Press ◄► to switch [GEOMETRY]. 2 )
The setting will change as follows each time z
◄► is pressed.
OFF KEYSTONE
PC CURVED
OFF
Geometry correction is not
performed.
KEYSTONE This adjusts projected images when
they are distorted to a trapezoid.
CURVED
This adjusts projected images
when they are distorted to a curved
surface.
PC Û
This is for performing geometry
correction from a computer.
GEOMETRY adjustment should be carried out by : Û
a person who is familiar with the projector or by
a service person because a high level of skill is
required to make successful adjustment.
Select [KEYSTONE] or [CURVED] in 3 )
Step 2), and press button.
The [GEOMETRY : KEYSTONE] or z
[GEOMETRY : CURVED] screen will be
displayed.
Press ▲▼ to select the desired 4 )
adjustment item, and press ◄► to
adjust the correction amount.
You can adjust the projection images as shown z
below.