Proxima ASA 4100/4200 - Manual (Page 20)

Setting Up the Desktop Projector™ 4100/4200 2-9
1 Unplug the Macintosh monitor cable from the computer.
2 Plug the end of the supplied VGA video cable with the large round collar
into the COMPUTER 1 IN port on the projector. Attach the VGA end of
the Mac - VGA cable adapter to the other end of the VGA video cable.
3 Plug the Mac end of the Mac - VGA cable adapter into the Macintosh
video port.
4 Connect the audio source to the projector's COMPUTER AUDIO 1 ports.
NOTE: If you are using a second computer video or audio source, plug their
outputs into the COMPUTER 2 IN and COMPUTER 2 AUDIO connectors.
Use the VGA - Mac monitor adapter and your existing monitor cable to
connect the projector to a separate computer monitor, so you can view
computer video on the projector screen and the monitor at the same time.
NOTE: The DP4100/4200 only supports the Multi-Sync standard as separate
monitors for Macintosh desktop computers.
5 To project and view the monitor at the same time, plug the monitor cable
into the Mac end of the VGA - Mac monitor adapter.
6 Plug the VGA end of the VGA - Mac monitor adapter into the MONITOR
OUT port on the projector.
7 Turn the projector on and press the key.
NOTE: An external monitor is not required to use the DP4100/4200.
Connecting Notebook Computers
Use the appropriate cable and adapter to connect your portable computer to
the projector.
MAC IICPU
To VIDEO
OUT Port
MAC - VGA
Adapter
VGA Cable
To COMPUTER 1
IN Port
Figure 2-12 Laptop connections