Panasonic CF-30KTPAXxM - Manual (Page 58)

9-35
Arranging the Keyboard
Assembly of LCD Cable Plate
㪇㫕㪇㪅㪌
㪇㫕㪇㪅㪌
㪇㫕㪇㪅㪌
㪇㫕㪇㪅㪌
Attach the
Keyboard
Spacer Tape
Attach the
Keyboard
Spacer Sheet
Attach the
Keyboard
Back Plate
Keyboard is installed
Plate hole
Reusing the attaching parts is impossible
1.Apply the load when attaching the attaching parts. 20~30
䰚䯴2~3Kgf䯵/cm2
1. Attach Keyboard , Keyboard Spacer Tape and Keyboard Back Plate.
(Insert the KB protrusions into the plate holes and determine the position.)
2. Attach Conductive Cloth to Keyboard Back Plate.
3. Attach Keyboard Spacer Sheet to Keyboard Back Plate.
(Ensure Keyboard Spacer Sheet does not run over the level of Keyboard Back Plate.)
Paste Conductive Cloth
Paste Conductive Cloth
1. Apply the load when attaching the attaching parts.
20~30N (2~3Kgf)/cm2
(Notes)
LCD CABLE COVE Set
KB CABLE COVER CUSHION Attach.
KB CABLE COVE Set
LCD CABLE COVER CUSHION Attach.
CD Edge Sheet Attach.
DFHR3M83ZA
LCD CABLE COVER CUSHION
KB CABLE COVER CUSHION
0~1mm
4~6mm
S3
CAUTION
S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
To prevent from
touching the
KBD Cable