Philips PV-GS55 - Manual (Page 24)

Before Use
-24-
[DATE/TIME]
Date and Time Indication
-62-
4) [LCD/EVF]
Adjusting Brightness and Color Level
[LCD/EVF SET]
LCD and Viewfinder Adjustment
-20-
[EVF ON/AUTO]
Using the Viewfinder
-19-
5) [INITIAL]
Initial Setup Sub-Menu
[AV JACK]
AV Jack
-73-
[REMOTE]
Remote Controller Mode
-15-
Setting Date and Time
Since the internal clock of the Palmcorder has a
slight imprecision make sure to check the time
before recording.
1 Set [INITIAL] >> [CLOCK SET] >> [YES].
2 Press the [ ;/∫] Button to select [YEAR],
[MONTH], [DAY], [HOUR] or [MIN.] and
press the [
6/5] Button to set it to the
desired value.
≥Year will cycle in the order shown below.
2000, 2001, ..., 2089, 2000, ...
3 Press the [MENU] Button (18) to finish
setting the date and time.
≥The clock operation starts from [00] second.
≥If the built-in battery is weak, the [ 0] Indication
flashes. In this case, charge the built-in battery.
≥The clock uses the 12-hour system.
Internal Lithium Battery Recharge
The internal lithium battery sustains the operation
of the clock. When the [
0] Indication flashes,
the internal lithium battery is near exhaustion.
MENU
STILL
ENTER
FADE
i s
(18)
CLOCK SET
1YEAR :2004
MONTH :JUL
DAY :12
HOUR : 3PM
MIN. :17
;/∫:SELECT &/%:SETUP
!/MENU:EXIT
1 Connect the AC Adaptor to the Palmcorder
with the power turned off and then connect
to the AC Jack.
≥After charging for 4 hours, the built-in lithium
battery can power the clock for approximately
3 months.
LP Mode
A desired recording speed can be selected with
[REC SPEED] on the [RECORDING] Sub-Menu.
If LP Mode is selected, the recording time
becomes 1.5 times longer than that of SP
Mode.
Although the image quality does not decrease
with the LP Mode recording, mosaic-pattern noise
may appear on a playback image, or some
normal functions may be restricted.
≥The contents that are recorded in LP Mode are
not completely compatible with other
equipment.
≥Audio dubbing is not possible with LP Mode.
( -46- )
Audio Recording Mode
The sound quality of the recorded sound can be
selected with [AUDIO REC] on the
[RECORDING] Sub-Menu.
High sound-quality recording is possible with
“16 bit 48 kHz 2 track” Mode. With the “12 bit
32 kHz 4 track” Mode, the original sound can be
recorded on 2 tracks in stereo, while the other
2 tracks can be used for Audio Dubbing.
PV-GS55PP_Eng.book 24 ページ ２００４年２月１０日 火曜日 午前１１時５１分