Polaris Outlaw 9920783 - Manual (Page 123)

120
MAINTENANCE AND LUBRICATION
Lights
Brake Light Adjustment
Check the rear brake light for proper operation before each use
of the vehicle.
1. Turn the ignition key on.
2. Lightly apply and release the foot brake several times. A
properly operating rear brakelight will immediately flash on
and off with each movement of the brake pedal.
3. If the light does not operate properly, grasp the switch body (1)
with a pliers or similar tool and hold it lightly, but securely.
Using a wrench, rotate the adjustment nut (2) clockwise to
increase tension on the spring (3).
NOTE: Rotate the adjusting nut counter-clockwise to decrease tension on the spring if
the brake light comes on when there is no pressure on the brake pedal.
4. Recheck and readjust as needed until the brake light operates properly.
1
2
3