Maintenance and lubrication – Polaris Outlaw 9920783 User Manual
Page 124
121
MAINTENANCE AND LUBRICATION
Front Cab Removal
1. Remove the screws (1) from the left and right cab
mounts.
2. Remove the wire harness connector from the cab.
The connector is located under the left fender.
3. Remove the fuel tank cover screws (2).
4. Remove the four side panel screws (3).
5. Gently pull the cab upward to disengage it from the stand-off.
Place the cab upside down on a soft protective surface to prevent
scratching.
Side Panel Removal
1. Unlatch and remove the seat.
2. Remove the front cab.
3. Remove the two screws (1) securing the
side panel.
4. Remove the side panel.
3
2
1
1
This manual is related to the following products: