Panasonic KX-FLB881 User Manual

Page 26

3. Printer

3.1.1 Using the manual input tray

You can print not only on plain paper but also on special
media (transparencies / labels / envelopes).
The manual input tray is used only for printing with the
computer and can hold one page at a time. When
printing multiple pages, add a next page after the first
page has been fed into the unit.

Please refer to page 89 for information on recording
paper.

Pull open the manual input tray (

1), and then raise

the extender (

2) gently until it clicks into place.

Insert the paper, print-side down (

1) until the unit

grasps the paper and a single beep is heard.

Adjust the width of the guides (

2) to the size of

the recording paper.

Note:

If the paper is not inserted correctly, re-adjust the
paper, or the paper may jam.

Make sure the unit grasps the recording paper as
specified in step 2. The display shows the following.

PAPER IN TRAY #2

FOR PC PRINTING

To use the manual input tray, you must change the
paper source in the [Basic] tab when setting the
printer properties (page 25). You can also select the
desired media type.

To print on transparencies
Use transparencies designed for laser printing.
We recommend the following:

CG3300/CG5000

Use the manual input tray to print
transparencies.

Load transparency sheets one page at a time for
printing, print-side down.

Printed transparency will be stacked on the
upper output tray.

Remove each transparency after printing and
place it on a flat surface to cool and to prevent it
from curling.

Do not re-use transparencies that have already been
fed through the unit. This includes transparencies
that have been fed through and ejected without being
printed on.

Some types of transparencies have instructions
recommending which side to print on. If the print
quality is poor, try printing on the other side of a new
transparency.

Load the recording paper after you have started
printing with the computer.

FLB881-PFQX2732ZA-OI-en.book Page 26 Wednesday, July 18, 2007 11:22 PM