Paradyne 7976 - Manual (Page 17)

17 7976-A2-GZ40-00 March 1999
"
Procedure
The AutoRate option is defaulted to Disable. To enable AutoRate:
1. Position the cursor in the AutoRate field and press the spacebar.
The AutoRate field toggles to Enable and the DSL Line Rate field displays.
2. Enter a DSL Line Rate and press Enter.
Your payload rate is set to a default value of 1984. Use Table 10, Fixed Rate
Payload Rates and DSL Line Rates, to set your DSL Line Rate and Payload
Rate according to whether you are configured for Voice (signaling) or Data.
Table 10 provides the maximum payload rates achievable for each DSL line rate
and the number of time slots required to achieve that payload rate depending on
whether you are using signaling (time slots 0 and 16) or data only (time slot 0).
Table 10. Fixed Rate Payload Rates and DSL Line Rates
Voice Mode
(G.703 to G.703) Data Mode
(G.703 to G.703) Data Mode
(G.703 to EIA-530)
DSL Line
Rate (kbps)
Maximum
Payload
Rate (kbps)
Time
Slots
Maximum
Payload
Rate (kbps)
Time
Slots
Maximum
Payload
Rate (kbps)
Time
Slots
2064 1920 30 1984 31 1984 31
1552 1408 22 1472 23 1536 24
1040 896 14 960 15 1024 16
784 640 10 704 11 768 12
528 384 6 448 7 512 8
400 256 4 320 5 384 6