Panasonic KX-FC225NZ - Manual (Page 18)

2. Preparation
18
Volume
2.4 Adjusting cordless handset
volume
Ringer volume
1. {j/OK}
2. Press {^} or {V} to select “ Handset Setup”. i
{>}
3. Press {^} or {V} to select “ Ringer Setup”. i
{>}
4. Press {^} or {V} to select “ Ringer Volume”. i
{>}
5. Press {^} or {V} to select the desired volume. i
{>} i {ih}
Note:
L When receiving a call, you can adjust the ringer
volume by pressing {^} or {V}.
L When the ringer is turned OFF, the cordless handset
will ring for alarm and intercom calls.
Ringtone
You can select the desired cordless handset ringtone for
outside calls and intercom calls (page 52).
Cordless handset receiver volume
While using the receiver, press {^} or {V}.
Speaker volume
While using the speakerphone, press {^} or {V}.
2.5 Adjusting base unit volume
Ringer volume
While the unit is idle, press {A} or {B}.
L If there are any documents in the document
entrance, you cannot adjust the volume. Confirm that
there are no documents in the entrance.
To turn the ringer OFF
Press {B} repeatedly to display “ RINGER OFF= OK?”.
i {SET}
L The base unit will not ring for outside calls.
The base unit will ring at the low level for intercom
calls.
L To turn the ringer back ON, press {A}.
Ringtone
L You can select the desired base unit ringtone for
outside calls (feature #17 on page 47).
Speaker volume
While using the speakerphone, press {A} or {B}.
{^}{V}{>}
{j /OK}
{ih}
{ SET}
{A}{B}
FC225-226AL-PFQX2518ZA-en.book Page 18 Friday, June 23, 2006 4:08 PM